13:20. Removal and installation of latches and cylinders of locks and external and internal handles of doors
Assembly of a latch of the lock
|
|
1. Lift a windowpane and remove the panel of an internal upholstery of a door (see Removal and installation of an internal upholstery of doors).
|
|
2. Through a big opening in a doorframe disconnect the rod connecting the external handle to a latch. Do the same with a rod of the internal handle, and also with rods of external and internal locks and the electromagnetic actuation mechanism (at the corresponding complete set) (see an accompanying illustration). |
3. All rods fasten by means of plastic clamps. Release the part of a clamp entering gearing with a rod, then pull a rod, releasing it from a landing opening.
|
|
4. Turn out screws of fastening of a latch to a door (see an accompanying illustration). Take assembly of a latch through the opening provided in a doorframe.
|
5. Installation is made upside-down. |
|
External handle and cylinder of the door lock
|
|
1. Close a window and remove the panel of an internal upholstery of a door and the water filter (see Removal and installation of an internal upholstery of doors).
|
|
2. Through an opening in a doorframe release plastic clamps of fastening to a latch of executive rods external the handle and the lock of a door (see an accompanying illustration). |
3. Turn out bolts of fastening of the external handle (see an illustration above).
4. Remove the handle and assembly of the cylinder of the lock from the car.
5. Installation is made upside-down. |
|
Internal handle
|
|
1. Remove the panel of an internal upholstery and separate the water filter (see Removal and installation of an internal upholstery of doors).
|
|
2. Release a guide of an executive rod, then turn out screws of fastening of the handle (see an accompanying illustration).
|
3. Release the handle from a door and disconnect an executive rod from its back party. Remove the handle.
4. Installation is made upside-down. |
|