4.2.13. Removal and installation of the pallet of a case of the engine

Removal

 PERFORMANCE ORDER

1. Warm up the engine up to the normal working temperature, then merge from it engine oil and remove an oil filter (see the Head Routine maintenance).
2. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that you have the correct combination for input of the audio system in action!


3. The car also establish to Poddomkratta it on props. Remove protection of a case.
4. Remove a reception pipe of system of production of the fulfilled gases (see the Head of the Power supply system and release).

5. Turn out bolts of fastening of the pallet to the engine block (see an accompanying illustration).

6. Having tapped the pallet on perimeter the hammer with soft brisk for the purpose of destruction of a layer of sealant, separate it from the block (you do not make at all attempts to hook the pallet under the interfaced surface).
7. Scratch out all traces of sealant and material of old laying from the interfaced surfaces of the pallet and block. Remove face sealing inserts from the pallet or the block. Carefully wipe the interfaced surfaces with the rags moistened in acetone. Clean and dry carving openings in the block.

Installation

 PERFORMANCE ORDER

1. Wash out the pallet solvent and carefully dry it. Make sure of lack of deformations of an adjusting flange of the pallet, in case of need lay the pallet a flange on the flat wooden block and make a rikhtovka.
2. Impose a pillow of RTV sealant 3 mm thick on a pro-masonry surface of a flange of the pallet. Track that sealant was imposed from the inside of bolted openings.
3. Accurately press the pallet to the block.
4. Screw bolts and in stages (on 1/4 turns for approach) tighten them with the required effort (see Specifications). Begin tightening with the bolt, next to the center, and move on a spiral outside. Remember that pulling of fixture is fraught with development of leaks.
5. Fill in engine oil (see the Head Routine maintenance), start the engine and check the pallet for existence of leaks.