4.2.6. Removal and installation of a final collector

Removal

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that you have the correct combination for input of the audio system in action!


2. A car front also establish to Poddomkratta it on props. Otboltite an assembly bracket also disconnect from a final collector a reception pipe of system of production of the fulfilled gases (see an accompanying illustration). If fixture of a pipe does not give in to an otdavaniye, previously moisten it with the getting structure.

3. Remove from a final collector the thermofilter (see an accompanying illustration). It is also expedient to impregnate fixture with previously getting structure.

4. Give fixing nuts (see an accompanying illustration) and separate a final collector from a head of cylinders.

Installation

 PERFORMANCE ORDER

1. You will throw out old laying, then scratch out its fragments from the interfaced surfaces of a final collector and a head of cylinders. Wipe surfaces with the rags moistened in acetone.
2. Having replaced laying, establish a collector on the regular place and fix it by nuts. Moving in the direction from the center outside, in a diagonal order tighten fixture with the required effort (see Specifications).
3. Further installation is made as it should be, the return to a dismantle order.
4. Start the engine and check it for existence of signs of leak of the fulfilled gases through joints of a final collector with a head of cylinders and a reception pipe of system of release.